Thirty minutes. So mostly misspelled words. Most implementations of this type of feature also have a small “Edited” flag.
My favorite one of these shows up in 3D printing. The most popular open source 3D print server gives you a head’s up if your printer’s firmware lacks “Thermal Runaway Protection”. If you click the learn more link, it patiently explains, “There aren’t preventative measures to stop your printer from accidentally catching itself on fire”.
(It’s fine, you usually just need to install a decent MOSFET in the cheaper printers.)
https://www.serverbuilds.net/ is a popular website online for folks building NASes at home. They’re fans of Unraid as well. They’ve got a Discord if you’re looking for something more interactive. Worth checking out. 👍
Millennial Republicans rock fans be like
Some dongles are limited to 4K@30. Like this one. You’ll want to double-check the specs of your adapter. They do make DP/HDMI to USB-C cables for what it’s worth. USB-C is a frustrating spec because you can run a lot of different standards over it. Even with cables you’ll want to make sure they’re not running some older spec.
I just double-checked your monitor’s manual. It looks like HDMI 1 can only do 30hz. Only HDMI 2 and the DP ports support 60hz. Were you trying to connect through HDMI 1?
Try plugging the Mac in without a dock.
A lot of docks out there are DisplayLink based, and you may need to install their driver to get the higher refresh rate.
Also try switching up which type cable you’re plugging into the dock. Most dock manuals have an esoteric support table based on whether or not you plugged in a DisplayPort or HDMI cable.
What are you talking about?